Brand: Toyota PRADO
Year model: 2008
Engine type: 2TR
Displacement: 2.7L
VIN：JTEBL29J685136893
Steering angle need to be set after unplug sensor plug, change steering sensor and replace electronic control device. Fcar diagnostic scanner are needed for setting, the method of which as below:
1, First find fault diagnostic plug(diagnostic plug of this vehicle under instrument panel, is standard OBD16 pin plug)
2, OBD；Connect diagnostic socket and OBD according to instruction of diagnostic scanner;
3, After confirm correct connection, open ignition switch and scanner switch;
4, Select corresponding menu to enter according to display of scanner
Japan——【TOYOTA】——【V6.4】——【ODBII connector】——【body】——【ABS】——【Work support】——【Reset memory】——【Use this function after replacing side slip control ECU or G and yaw rate sensor, {Introduction}this function used for resetting learning value of side slip control ECU{Confirm}】——【Welcome to use reset memory function,this function used to remove learning value of ABS,ECU. Prompt: after replaced ABS, ECU or G sensor, use this function to reset learning value of ABS,EDU.{Confirm}】——【Note: Check initial conditions. Vehicle stopped. IG switch in ON{Confirm}】——【reset memory has completed, please press Back button to return】
Test mode——【 use this function{Introduction}after replacing side slip control ECU or G and Yaw rate sensor. This function used for calibrating zero of G and yaw rate sensor, pls click ”Next step” to continue】——【 Welcome to use test mode function, this function can be used to calibrating yaw rate sensor after replacing a certain following part——ABS ECU yaw rate G sensor,click“Next”to continue】——【Confirm the following conditions, vehicle on flat surface, steering wheel in frontal position, shift lever in parking position, engine running, vehicle IG in ON position, pls click “Next” to continue 】——【Keep vehicle static for 2s or longer, click ”Next ”to continue】——【if ABS VCS light on, calibration complete, if not, please try again】.

Select needed function according to prompt
Reset memory
This function used for deleting learning value of ABS ECU(Use this function to reset learning value of ABS ECUW after replacing ABS ECU or YAWRATE sensor).

Test mode
Use this function after replacing side slip control ECU or yaw rate sensor (This function used for calibrating zero of yaw rate sensor)

To add a comment please login by clicking here